BSW/BSI System Settings Cannot Be Turned On/Off On The Navigation Screen

BSW/BSI SYSTEM SETTINGS CANNOT BE TURNED ON/OFF ON THE NAVIGATION SCREEN

Description

- BSW system setting is not selectable on the navigation screen.
- BSI system setting is not selectable on the navigation screen.
NOTE:
When the ignition switch is in ACC position, BSW or BSI system settings cannot be changed.
- "Blind Spot Warning" or "Blind Spot Intervention" is not indicated on the navigation screen.
- The switching between ON and OFF cannot be performed by operating the navigation system.
- The item "Blind Spot Warning" or "Blind Spot Intervention" on the navigation screen is not active.
- The BSW or BSI system setting differs from the one set at the previous driving.
NOTE:
Turn OFF the ignition switch and wait for 5 seconds or more.


Diagnosis Procedure


1. CHECK BSI SYSTEM SETTING

1.Start the engine.
2.Check that the BSI system settings is selectable on the navigation screen.
Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. PERFORM THE SELF-DIAGNOSIS

1.Perform self-diagnosis with CONSULT.
2.Check if the DTC is detected in self-diagnosis results of "ICC/ADAS", "MULTI AV" and "METER/M&A".
Refer to the following.
-ICC/ADAS: Testing and Inspection
-MULTI AV: Testing and Inspection
-METER/M&A: Testing and Inspection
Is any DTC detected?
YES- Repair or replace malfunctioning parts.
NO- INSPECTION END

3. CHECK DATA MONITOR OF ADAS CONTROL UNIT

Check that "BSI SELECT" operates normally in "DATA MONITOR" of "ICC/ADAS" with CONSULT.
Is the inspection result normal?
YES- Bose Audio.
NO- GO TO 4.

4. CHECK MULTIFUNCTION SWITCH

Operate the multifunction switch to check that the audio, navigation system, and air conditioner operate properly.
Is the inspection result normal?
YES- Replace the ADAS control unit. Service and Repair.
NO- Repair or replace malfunctioning parts.