Side Oil Seal

SIDE OIL SEAL

Removal and Installation


REMOVAL

1.Remove final drive assembly. Removal And Installation.
NOTE:
It is necessary to remove final drive assembly to remove the rear drive shaft.
2.Remove side oil seal, using a suitable tool.

CAUTION:
Never damage gear carrier.

INSTALLATION

1.Apply multi-purpose grease to side oil seal lips.





2.Install side oil seal until it becomes flush with the case end, using the drift (A) [SST: ST-35271000 (J-26091)].

CAUTION:
- Never reuse oil seal.
- When installing, never incline oil seal.
3.Install final drive assembly. Removal And Installation.
4.When oil leaks while removing, check oil level after the installation. Inspection.