Removal And Installation

EVAP CANISTER

Removal and Installation


REMOVAL

1.Remove the rear diffuser. .
2.Disconnect harness connectors (EVAP control system pressure and EVAP canister vent control valve)
and EVAP canister hoses.
3.Remove EVAP canister fixing bolt.
4.Remove EVAP canister.
NOTE:
The EVAP canister vent control valve and EVAP control system pressure sensor can be removed without removing the EVAP canister.

INSTALLATION

Install in the reverse order of removal.
NOTE:
Tighten EVAP canister fixing bolt to the specified torque.