Description

INSPECTION AND ADJUSTMENT

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description

When the control unit is replaced, the initialization is necessary.
If any of the following operations are performed, the initialization is necessary and the control unit must be disconnected.
- Power supply to the power window switch or power window motor is cut off by removal of battery terminal or if the battery fuse is blown.
- Disconnection and connection of power window switch harness connector.
- Removal and installation of motor from regulator assembly.
- Operation of regulator assembly as an independent unit.
- Removal and installation of door glass or door glass run.
The following specified operations cannot be performed under the non initialized condition.
- Auto-up operation
- Anti-pinch function
- Key cylinder switch power window function
- Automatic window adjusting function