Precaution For Removal and Installation of 4WAS Components

PRECAUTIONS

Precautions for Removal and Installation of 4WAS Components

- Set the vehicle to the straight-ahead position when checking 4WAS and removing each component.
- Remove the battery terminal 10 minutes after turning the ignition switch OFF from ON and perform the removal of each component when removing the 4WAS front control unit.
- Perform the neutral position adjustment for the steering angle sensor after the replacement of steering angle sensor. Special Repair Requirement.
- Description for the replacement of 4WAS front control unit.
- Description for the replacement of 4WAS front actuator.