C1210

C1210 ECM

Description

Transmits the following signals via CAN communication to AWD control unit.
- Accelerator pedal position signal
- Engine speed signal


DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. DTC REPRODUCTION PROCEDURE

With CONSULT
1.Start the engine. Drive the vehicle for a while.
2.Perform self-diagnosis for "ALL MODE AWD/4WD".
Is DTC "C1210" detected?
YES- Proceed to diagnosis procedure. .
NO- INSPECTION END


Diagnosis Procedure


1. PERFORM ECM SELF-DIAGNOSIS

With CONSULT
Perform self-diagnosis for "ENGINE".
Is any DTC detected?
YES- Check the DTC.
NO- GO TO 2.

2. PERFORM SELF-DIAGNOSIS

With CONSULT
1.Erase self-diagnostic results for "ALL MODE AWD/4WD".
2.Turn the ignition switch OFF.
3.Start the engine. Drive the vehicle for a while.
4.Make sure that malfunction indicator lamp (MIL) turns OFF.
5.Stop the vehicle. Perform self-diagnosis for "ALL MODE AWD/4WD".
Is DTC "C1210" detected?
YES- Replace AWD control unit. Exploded View.
NO- Check AWD control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace error-detected parts.