B260F

Description

BCM receives the engine status signal from ECM via CAN communication.


DTC Logic


DTC DETECTION LOGIC

NOTE:
- If DTC B260F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
Security System.
- If DTC B260F is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to
Security System.






DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn ignition switch ON under the following conditions.
-Selector lever is in the P or N position
-Do not depress brake pedal
-Do not depress clutch pedal
2.Check "Self-diagnostic result" using CONSULT.
Is DTC detected?
YES- Go to .
NO- INSPECTION END


Diagnosis Procedure


1. INSPECTION START

1.Turn ignition switch ON.
2.Check "Self-diagnostic result" using CONSULT.
3.Touch "ERASE".
4.Perform DTC Confirmation Procedure.
See .
Is the DTC B260F displayed again?
YES- GO TO 2.
NO- GO TO 3.

2. REPLACE ECM

Replace ECM. For USA and Canada.
- INSPECTION END

3. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
- INSPECTION END