Diagnosis Procedure

DOOR MIRROR REMOTE CONTROL SWITCH

MIRROR SWITCH : Diagnosis Procedure


1. CHECK MIRROR SWITCH INPUT SIGNAL

1.Turn ignition switch OFF.
2.Disconnect door mirror remote control switch connector.
3.Turn ignition switch ON.
4.Check voltage between door mirror remote control switch harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. CHECK MIRROR SWITCH CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect automatic drive positioner control unit connector.
3.Check continuity between automatic drive positioner control unit harness connector and door mirror remote control switch harness connector.





4.Check continuity between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES- Replace automatic drive positioner control unit. Removal and Installation.
NO- Repair or replace harness.

3. CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT

1.Turn ignition switch OFF.
2.Check continuity between door mirror remote control switch harness connector and ground.





Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace harness.

4. CHECK MIRROR SWITCH

Check door mirror remote control switch (mirror switch).
Refer toComponent Inspection.
Is the inspection result normal?
YES- GO TO 5.
NO- Replace door mirror remote control switch (mirror switch). Removal and Installation.

5. CHECK INTERMITTENT INCIDENT

Check intermittent incident.
Intermittent Incident.
- INSPECTION END