Door Sensor/Switch (For Alarm): Testing and Inspection

DOOR SWITCH

Description

Detects door open/close condition.


Component Function Check


1. CHECK FUNCTION

Check ("DOOR SW-DR" or "DOOR SW-AS") in BCM "Data Monitor" mode using CONSULT-III.





Is the inspection result normal?
YES- Door switch is OK.
NO- .


Diagnosis Procedure


1. CHECK DOOR SWITCH INPUT SIGNAL

1.Turn ignition switch OFF.
2.Disconnect malfunctioning door switch connector.
3.Check signal between malfunctioning door switch harness connector and ground using oscilloscope.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. CHECK DOOR SWITCH CIRCUIT

1.Disconnect BCM connector.
2.Check continuity between door switch harness connector and BCM harness connector.





3.Check continuity between door switch harness connector and ground.





Is the inspection result normal?
YES- Replace BCM. Removal and Installation.
NO- Repair or replace harness.

3. CHECK DOOR SWITCH GROUND CIRCUIT

Check continuity between door switch harness connector and ground.





Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace harness.

4. CHECK DOOR SWITCH

.
Is the inspection result normal?
YES- GO TO 5.
NO- Replace malfunctioning door switch. Removal and Installation.

5. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
- INSPECTION END


Component Inspection


1. CHECK DOOR SWITCH

1.Turn ignition switch OFF.
2.Disconnect malfunctioning door switch connector.
3.Check continuity between door switch terminals.





Is the inspection result normal?
YES- INSPECTION END
NO- Replace malfunction door switch. Removal and Installation.