Information

NOTE:
^ Before starting, make sure your ASIST has been freshly synchronized and all CONSULT-III (C-III) plus upgrades have been installed.

^ The Multi-AV reprogramming (reconfigure) software is delivered to C-III plus via ASIST synchronization.

There are six parts to this procedure:

Part 1: Using C-III plus - record (write down) the Multi AV control unit part number and configuration settings.

Part 2: Using the vehicles on-board Systems Diagnostic Menu - perform Multi AV initialization.

Part 3: Using C-III plus - reprogram (reconfigure) the Multi AV and confirm the control unit part number has changed.

Part 4: Make sure the Multi AV system is operational.

Part 5: Replace the system microphone with the one from the Parts Information section of this bulletin and install a new map lamp finisher.

Part 6: Check microphone operation using the vehicles on-board Systems Diagnostic Menu.