Removal and Installation

INTAKE SENSOR

Removal and Installation


REMOVAL

1.Remove low-pressure pipe 1 and high-pressure pipe 2. Exploded View.
2.Slide evaporator to passenger side, and then remove intake sensor.
3.Disconnect intake sensor connector.

INSTALLATION

Installation is basically the reverse order of removal.

CAUTION:
- Replace O-rings with new ones. Then apply compressor oil to them when installing.
- Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor can be located in the same position.
- Female-side piping connection is thin and easy to deform. Slowly insert the male-side piping straight in axial direction.
- Insert piping securely until a click is heard.
- After piping connection is completed, pull male-side piping by hand to make sure that connection does not come loose.
- Check for leakages when recharging refrigerant.