Removal And Installation

REAR OIL SEAL


Removal and Installation


REMOVAL
1. Remove the rear propeller shaft. Removal And Installation.
2. Remove self-lock nut of companion flange with a flange wrench (commercial service tool).





3. Put matching mark (A) on the end of the main shaft. The mark should be in line with the mark (B) on the companion flange.

CAUTION:
For matching mark, use paint. Never damage main shaft.





4. Remove the companion flange with a puller (A) (commercial service tool).

CAUTION:
Never damage the companion flange.





5. Remove the rear oil seal with the puller (A) [SST: KV381054S0
(J-34286)].

CAUTION:
Never damage the rear case.

INSTALLATION





1. Apply transfer fluid to rear oil seal, install it with the drifts within the dimension (L) shown as follows.

A : Drift [SST: ST30720000 (J-25405)]
B : Drift [SST: KV40104830 ( - )]
L : 6.7 - 7.3 mm (0.264 - 0.287 in)

CAUTION:
- Never reuse rear oil seal.
- Apply petroleum jelly to oil seal lip.
- When installing, never incline rear oil seal.





2. Align the matching mark (A) of main shaft with the mark (B) of companion flange, then install the companion flange.





3. Using a flange wrench (A) (commercial service tool), install the self-lock nut of companion flange and tighten to the specified torque. Exploded View.

CAUTION:
Never reuse self-lock nut.

4. Install the rear propeller shaft. Removal And Installation.
5. Check fluid level. Inspection.