Inspection After Removal

REAR SUSPENSION ASSEMBLY


Inspection and Adjustment


ADJUSTMENT BEFORE REMOVAL
Adjust neutral position of 4WAS front actuator. (With 4WAS) Work Procedure (Pattern 1).

INSPECTION AFTER REMOVAL
Check rear suspension member for deformation, cracks, or any other damage. Replace if necessary.

INSPECTION AFTER INSTALLATION
1. Check wheel sensor and harness for proper connection. Exploded View.
2. Adjust parking brake operation (stroke). Inspection.
3. Check wheel alignment. Rear Suspension Wheel Alignment Inspection.
4. Adjust neutral position of steering angle sensor. (Without 4WAS) Work Procedure.
5. Adjust neutral position of 4WAS front actuator. (With 4WAS) Work Procedure (Pattern 2).
6. Adjust levelizer adjustment of height sensor. (With AFS) Description Xenon Type Special Repair Requirement Xenon Type Description Xenon Type Special Repair Requirement Xenon Type Description Xenon Type Special Repair Requirement Xenon Type, "ADDITIONAL SERVICE
WHEN REPLACING CONTROL UNIT (HEIGHT SENSOR) : Special Repair Requirement".