Removal And Installation

REAR LOWER LINK


Removal and Installation


REMOVAL
1. Perform adjustment before removal. (With 4WAS) Inspection And Adjustment.
2. Remove tires with power tool. Removal And Installation.
3. Set suitable jack under axle housing.

CAUTION:
Check that jack supporting status is stable.
4. Separate shock absorber from axle housing. Removal And Installation.
5. Remove eccentric disc, adjusting bolt, mounting bolt, and nut. Remove rear lower link.
6. Perform inspection after removal. Inspection And Adjustment.

INSTALLATION
Note the following, and install in the reverse order of removal.
- Perform final tightening of rear suspension member installation position (rubber bussing), under unladen conditions with tires on level ground.
- Perform inspection after installation. Inspection And Adjustment.