Work Procedure (Pattern 1)

4WAS FRONT ACTUATOR NEUTRAL POSITION ADJUSTMENT


Work Procedure (Pattern 1)

1. 4WAS FRONT ACTUATOR ADJUSTMENT
With CONSULT-III
1. Start the engine.

CAUTION:
Never drive the vehicle.
2. Turn the steering wheel to adjust "ACTR ROTA ANG" of the 4WAS front control unit "DATA MONITOR" so that it falls within the range shown below:

ACTR ROTA ANG : (-3.5) - (+3.5) deg

3. Turn the ignition switch OFF.

CAUTION:
Never touch the steering wheel after turning ignition switch OFF.
- END