Removal And Installation

4WAS REAR ACTUATOR ASSEMBLY


Removal and Installation


REMOVAL
1. Remove fixing bolts and nuts of 4WAS rear actuator from lower link. Removal And Installation.
2. Disconnect harness connector from 4WAS rear actuator and rear suspension member.
3. Remove fixing bolts and nuts of 4WAS rear actuator, and then remove 4WAS rear actuator from rear suspension member.

INSTALLATION
Note the following, and install in the reverse order of removal.
- When installing 4WAS rear actuator to rear suspension member, check the mounting surfaces of 4WAS rear actuator and rear suspension member for oil, dirt, sand, or other foreign materials.
- Check rear wheel alignment. Rear Suspension Wheel Alignment Inspection.