Removal And Installation

CRASH ZONE SENSOR


Removal and Installation


WARNING:
- Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more.
- Never use the air tools or electric tools for servicing.

REMOVAL
1. Remove the air duct. Removal And Installation.
2. Remove the reservoir tank.
- VQ engine: Exploded View.
- VK engine: Exploded View.
3. Remove the crash zone sensor fixing nut.
4. Disconnect the crash zone sensor harness connector.

CAUTION:





- Never impact the crash zone sensor.
- Replace the crash zone sensor if it has been dropped or sustained an impact.
- Replace the crash zone sensor of deployed driver air bag and deployed front passenger air bag.

INSTALLATION
Note the following items, and then install in the reverse order of removal.

CAUTION:
- Never use the old fixing nut after removal, replace with the new nut.
- If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunctioning parts, reset the memory using self-diagnosis or CONSULT-III. On Board Diagnosis Function or Scan Tool Testing and Procedures.
- After the work is completed, check that no system malfunction is detected by air bag warning lamp.