Special Repair Requirement

ADDITIONAL SERVICE WHEN REPLACING TRANSMISSION ASSEMBLY


Special Repair Requirement

1.PREPARATION BEFORE CALIBRATION PROCEDURE
1. Park the vehicle on a flat road.
2. Adjust pressure in all tires to the specified value. [1][2]Specifications.
- GO TO 2.
2.PERFORM CALIBRATION
With CONSULT-III
1. Turn ignition switch ON.

CAUTION:
Never start the engine.
2. Select "G SENSOR CALIBRATION" in "Work Support" in "TRANSMISSION".
3. Touch "START".

CAUTION:
Never give any motion to the vehicle during the calibration.
Is "completed" displayed?
YES - GO TO 3.
NO - Perform the calibration again.
3.CHECK DTC
With CONSULT-III
Select "Self Diagnostic Results" in "ABS".
Is "C1145" or "C1146" detected?
YES - Testing and Inspection.
NO - Calibration end.