High-Pressure Pipe Removal And Installation

COOLER PIPE AND HOSE


HIGH-PRESSURE PIPE HIGH-PRESSURE PIPE : Removal and Installation


REMOVAL
1. Remove low-pressure flexible hose and low-pressure pipe 1. and .
2. Disconnect vacuum hose and vacuum piping. Removal And Installation.
3. Remove ground bolts.
4. Remove high-pressure pipe 1 from vehicle clip.
5. Disconnect one-touch joint between high-pressure pipe and condenser pipe assembly with disconnector
(SST: 9253089908).

CAUTION:
Cap or wrap the joint of the A/C piping with suitable material such as vinyl tape to avoid the entry of air.
6. Disconnect one-touch joint between evaporator pipe assembly and high-pressure pipe with disconnector
(SST: 9253089908).

CAUTION:
Cap or wrap the joint of the A/C piping with suitable material such as vinyl tape to avoid the entry of air.
7. Remove high-pressure pipe.

INSTALLATION
Note the following items, install in the reverse order of removal.

CAUTION:
- Replace O-rings with new ones. Then apply compressor oil to them when installing.
- Female-side piping connection is thin and easy to deform. Slowly insert the male-side piping straight in axial direction.
- Insert piping securely until a click is heard.
- After piping connection is completed, pull male-side piping by hand to check that connection never come loose.
- Check for leakages when recharging refrigerant. Leak Test.