Intake Sensor Removal And Installation

INTAKE SENSOR


Removal and Installation


REMOVAL
1. Remove evaporator assembly. .
2. Remove intake sensor from evaporator assembly.

INSTALLATION
Note the following items, install in the reverse order of removal.

CAUTION:
- Replace O-ring with new ones. Then apply compressor oil to them when installing.
- Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor can be located in the same position.
- Female-side piping connection is thin and easy to deform. Slowly insert the male-side piping straight in axial direction.
- Insert piping securely until a clicks is heard.
- After piping connection is completed, pull male-side piping by hand to make sure that connection does not come loose.
- Check for leakages when recharging refrigerant. Leak Test.