BSW & BSI

ACTION TEST


Work Procedure


WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION:
Fully understand the following items well before the road test;
- Precautions: Precaution For BSW/BSI System Service.
- System description for BSW: .
- System description for BSI: .
- Normal operating condition: BSW & BSI.
1.LDW/LDP SYSTEM ACTION TEST
Perform the LDW/LDP system action test. Inspection Procedure.
- GO TO 2.
2.BSW SYSTEM ACTION TEST
1. Drive the vehicle.
2. Turn warning systems switch ON (warning systems ON indicator is ON).

NOTE:
BSI system is OFF.
3. Check BSW operation according to the following table.






- GO TO 3.
3.CHECK BSI SYSTEM SETTING
1. Start the engine.
2. Check that the BSI system setting can be enabled/disabled on the navigation screen.
3. Turn OFF the ignition switch and wait for 5 seconds or more.
4. Check that the previous setting is saved when the engine starts again.
- GO TO 4.
4.CHECK DYNAMIC DRIVER ASSISTANCE SWITCH
1. Start the engine.
2. After starting the engine wait for 5 seconds or more.
3. Enable the setting of the BSI system on the navigation screen.
4. Press the dynamic driver assistance switch.
5. Check that the BSI ON indicator on the combination meter illuminates.
6. Check that the BSI ON indicator turns OFF when the system is turned OFF by pressing the dynamic driver assistance switch.
7. Check that the BSI ON indicator turns OFF when the engine starts again.

NOTE:
- The BSI ON indicator does not illuminate even when the dynamic driver assistance switch is turned ON within approximately 5 seconds after starting the engine.
- When the BSI system setting is disabled on the navigation screen, the BSI ON indicator is not turned ON by pressing the BSI switch.
- INSPECTION END