C1705

C1704, C1705, C1706, C1707 LOW TIRE PRESSURE





DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION
With CONSULT-III
1. Turn the ignition switch ON.

CAUTION:
Never start the engine.
2. Check the tire pressure for all wheels and adjust to the specified value. [1][2]Specifications.
3. Perform self-diagnosis for "AIR PRESSURE MONITOR".
Is DTC "C1704", "C1705", "C1706", or "C1707" detected?
YES - Proceed to SEE Diagnosis Procedure.
NO - INSPECTION END




Diagnosis Procedure
1.CHECK TIRE PRESSURE
Check the air pressure of all wheels. [1][2]Specifications.
Is the inspection result normal?
YES - Replace the DTC-detected malfunctioning transmitter. Removal And Installation.
NO - After adjusting the air pressure, GO TO 2.
2.CHECK TIRE PRESSURE SIGNAL
With CONSULT-III
1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.
2. Stop the vehicle.
3. Select "DATA MONITOR" for "AIR PRESSURE MONITOR" with CONSULT-III.
4. Within 5 minutes after vehicle stopped, check that the tire pressures match the standard value.





Is the inspection result normal?
YES - INSPECTION END
NO - Repair or replace error-detected parts.