Removal And Installation

AIR BREATHER HOSE


Removal and Installation


REMOVAL
1. Remove clips of air breather hose from brackets.
2. Remove air breather box from bracket.
3. Remove air breather box from air breather hose.
4. Remove air breather hose.
5. Separate propeller shaft assembly. Exploded View.
6. Remove control rod from A/T shift selector assembly. Exploded View.
7. Support A/T assembly with a transmission jack.

CAUTION:
When setting the transmission jack, be careful not to allow it to collide against the drain plug and overflow plug.
8. Remove rear engine mounting member with a power tool. Exploded View.
9. Remove bolt fixing A/T assembly to engine with a power tool.
10. Remove bracket.

INSTALLATION
Note the following, and install in the reverse order of removal.

CAUTION:
- When installing air breather hose, be careful not to be crushed or blocked by folding or bending the hose.
- When inserting air breather hose to air breather tube, be sure to insert it fully until its end reaches the radius curve end.
- When inserting air breather hose to air breather box, be sure to insert it fully until its end reaches the stop.
- Install air breather hose to air breather box so that the paint mark is facing backward.
- Ensure clips are securely installed to brackets when installing air breather hose to brackets.