Procedures

FRONT COIL SPRING AND SHOCK ABSORBER


Disposal

1. Set shock absorber horizontally with the piston rod fully extended.





2. Drill 2 � 3 mm (0.08 � 0.12 in) hole at the position ( Circle ) from top as shown in the figure to release gas gradually.

CAUTION:
- Wear eye protection (safety glasses).
- Wear gloves.
- Be careful with metal chips or oil blown out by the compressed gas.

NOTE:
- Drill vertically in this direction ( Arrow ).
- Directly to the outer tube avoiding brackets.
- The gas is clear, colorless, odorless, and harmless.

A : 20 - 30 mm (0.79 - 1.18 in)

3. Position the drilled hole downward and drain oil by moving the piston rod several times.

CAUTION:
Dispose of drained oil according to the law and local regulations.