Special Repair Requirement

INSPECTION AND ADJUSTMENT


ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION : Special Repair Requirement


ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION

CAUTION:
To adjust neutral position of steering angle sensor, make sure to use CONSULT-III.
(Adjustment cannot be done without CONSULT-III.)
1.ALIGN THE VEHICLE STATUS
Stop vehicle with front wheels in straight-ahead position.
- GO TO 2.
2.PERFORM THE NEUTRAL POSITION ADJUSTMENT FOR THE STEERING ANGLE SENSOR
1. Select "ABS", "WORK SUPPORT" and "ST ANGLE SENSOR ADJUSTMENT" in order with CONSULT-III.
2. Select "START".

CAUTION:
Never touch steering wheel while adjusting steering angle sensor.
3. After approximately 10 seconds, select "END".

NOTE:
After approximately 60 seconds, it ends automatically.
4. Turn the ignition switch OFF, then turn it ON again.

CAUTION:
Be sure to perform above operation.
- GO TO 3.
3.CHECK DATA MONITOR
1. Run the vehicle with front wheels in straight-ahead position, then stop.
2. Select "ABS", "DATA MONITOR" and "STR ANGLE SIG" in order with CONSULT-III, and check steering angle sensor signal.

STR ANGLE SIG : 0�2.5�

Is the steering angle within the specified range?
YES - GO TO 4.
NO - Perform the neutral position adjustment for the steering angle sensor again, GO TO 1.
4.ERASE THE SELF-DIAGNOSIS MEMORY
Erase self-diagnosis memories for "ABS", "ENGINE" and "ICC" with CONSULT-III.
- "ABS": Scan Tool Testing and Procedures.
- "ENGINE": On Board Diagnostic (OBD) System.
- "ICC": Consult-III Function (ICC/ADAS).
Are the memories erased?
YES - INSPECTION END
NO - Check the items indicated by the self-diagnosis.