Tire Pressure Monitor Receiver / Transponder: Testing and Inspection

TIRE PRESSURE RECEIVER





Component Function Check
1.TIRE PRESSURE MONITORING SYSTEM OPERATION
With CONSULT-III
1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.
2. On "DATA MONITOR", select "AIR PRESS FL", "AIR PRESS FR", "AIR PRESS RR" and "AIR PRESS
RL", and check that the tire pressures match the standard value.






CAUTION:
Stop the vehicle and within 5 minutes, use CONSULT-III "DATA MONITOR" to display the tire pressure for all wheels.
Is the inspection result normal?
YES - INSPECTION END
NO - Perform trouble diagnosis. SEE Diagnosis Procedure.




Diagnosis Procedure
1.CHECK TIRE PRESSURE RECEIVER SIGNAL
1. Turn the ignition switch ON.

CAUTION:
Never start the engine.
2. Check tire pressure receiver connector and ground signal with oscilloscope.






Is the inspection result normal?
YES - INSPECTION END
NO - GO TO 2.
2.CHECK TIRE PRESSURE RECEIVER INPUT VOLTAGE
1. Disconnect tire pressure receiver connector.
2. Check voltage between tire pressure receiver connector and ground.





Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace damaged parts.
3.CHECK TIRE PRESSURE RECEIVER GROUND CIRCUIT
1. Disconnect BCM harness connector.
2. Check continuity between BCM harness connector and tire pressure receiver connector.





3. Check continuity between BCM harness connector and ground.





Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace damaged parts.
4.CHECK BCM CIRCUIT
Inspect the BCM circuit. C1734.
Is the BCM circuit normal?
YES - Replace tire pressure receiver. Exploded View.
NO - Replace BCM. Exploded View.