With Daytime Running Light System

TAIL LAMP CIRCUIT - WITH DAYTIME RUNNING LIGHT SYSTEM





Component Function Check
1.CHECK TAIL LAMP OPERATION
IPDM E/R AUTO ACTIVE TEST
1. Activate IPDM E/R auto active test. Diagnosis Description.
2. Check that the tail lamp is turned ON.
CONSULT-III ACTIVE TEST
1. Select "EXTERNAL LAMPS" of IPDM E/R active test item.
2. With operating the test items, check that the tail lamp is turned ON.

TAIL : Tail lamp ON
Off : Tail lamp OFF

Is the tail lamp turned ON?
YES - Tail lamp circuit is normal.
NO - SEE Diagnosis Procedure.




Diagnosis Procedure
1.CHECK TAIL LAMP OPEN CIRCUIT
1. Turn the ignition switch OFF.
2. Remove the daytime running light relay.
3. Disconnect the rear combination lamp connector.
4. Check continuity between the daytime running light relay harness connector and the rear combination lamp harness connector.





Does continuity exist?
YES - GO TO 2.
NO - Repair the harnesses or connectors.
2.CHECK TAIL LAMP GROUND OPEN CIRCUIT
Check continuity between the rear combination lamp harness connector and the ground.





Does continuity exist?
YES - Replace the rear combination lamp.
NO - Repair the harnesses or connectors.