Tire Monitoring System: Service and Repair

ID REGISTRATION


Work Procedure

1.TIRE PRESSURE SENSOR ID REGISTRATION PROCEDURE
With CONSULT-III.
1. Display the "WORK SUPPORT" screen and select "ID REGIST".
Is the activation tool (J-45295) used for the tire pressure sensor ID registration procedure?
YES - GO TO 2.
NO - GO TO 3.
2.TIRE PRESSURE SENSOR ID REGISTRATION PROCEDURE (WITH ACTIVATION TOOL)
1. Turn the ignition switch ON.
2. Select the start button on the "ID REGIST" screen.





3. Contact the activation tool (J-45295) (1) to the side of the tire at the location to the tire pressure sensor.
4. Press and hold the activation tool button while pushing the tool to the tire surface. (approximately for 5 seconds)

CAUTION:
Perform the ID registration procedure starting from the vehicle front left wheel, then repeat the procedure in the order of the front right wheel, rear right wheel, and rear left wheel.
5. When ID registration is completed, check the following pattern at each wheel.





6. After the ID registration procedure for all wheels is completed, press "END" to end ID registration, and check that ID registration for all wheels is completed.
Is the check result normal?
YES - ID registration END.
NO - Performs trouble-diagnosis of the Tire Pressure Monitoring System (TPMS). Testing and Inspection.
3.TIRE PRESSURE SENSOR ID REGISTRATION PROCEDURE (WITHOUT ACTIVATION TOOL)
1. Adjust the tire pressure for all wheels to match the list below.





2. Drive the vehicle at a speed at more than 40 km/h (25 MPH) for 3 minutes or more, then perform the tire pressure sensor ID registration procedure.
3. After ID registration for all wheels is completed, press "END" to end ID registration.





4. Adjust the tire pressures for all wheels to the specified value. [1][2]Specifications.
Is ID registrations for all wheels completed?
YES - ID registration END.
NO - Performs trouble-diagnosis of the Tire Pressure Monitoring System (TPMS). Testing and Inspection,
"DTC Index".