Inspection Procedure

MEMORY FUNCTION DOES NOT OPERATE


Inspection procedure

1.CHECK OPERATION
1. Set temperature control dial to 32�C (90�F).
2. Press OFF switch.
3. Turn ignition switch OFF.
4. Turn ignition switch ON.
5. Press AUTO switch.
6. Check that the set temperature is maintained.
Is the inspection result normal?
YES - INSPECTION END
NO - GO TO 2.
2.CHECK POWER SUPPLY AND GROUND CIRCUIT OF UNIFIED METER AND A/C AMP.
Check power supply and ground circuit of unified meter and A/C amp. .
Is the inspection result normal?
YES - Replace unified meter and A/C amp.
NO - Repair or replace malfunctioning part.