ICC System Does Not Cancel When A/T Selector Lever Sets On "N"

ICC SYSTEM DOES NOT CANCEL WHEN A/T SELECTOR LEVER SETS ON "N"





Description
The ICC system is not canceled even when the A/T selector lever is shifted to the N position while the ICC system is active.




Diagnosis Procedure
1.CHECK D RANGE SWITCH
Check if "D RANGE SW" operates normally in "DATA MONITOR" of "ICC/ADAS" with CONSULT-III.
Is the inspection result normal?
YES - GO TO 6.
NO - GO TO 2.
2.PERFORM ALL SELF-DIAGNOSIS ITEMS
1. Perform "All DTC Reading".
2. Check if the "U1000" is detected in "self-diagnosis results" of "ICC/ADAS".
Is "U1000" detected?
YES - GO TO 3.
NO - GO TO 4.
3.CAN COMMUNICATIONS INSPECTION
Check the CAN communication and repair or replace malfunctioning parts. Cruise Control.
- INSPECTION END
4.CHECK POSITION SWITCH
Check if "SLCT LVR POSI" operates normally in "DATA MONITOR" of "TRANSMISSION".
Is the inspection result normal?
YES - GO TO 6.
NO - GO TO 5.
5.PERFORM TCM SELF-DIAGNOSIS
1. Perform the "Self Diagnostic Result" of "TRANSMISSION".
2. Repair or replace malfunctioning parts. Testing and Inspection.
- GO TO 7.
6.REPLACE ICC SENSOR INTEGRATED UNIT
1. Replace the ICC sensor integrated unit. Exploded View.
2. Perform the laser beam aiming. Description.
- GO TO 7.
7.CHECK ICC SYSTEM
1. Erase the self-diagnosis results, and then perform "All DTC Reading" again after performing the action test. ( Description for action test.)
2. Check that the ICC system is normal.
- INSPECTION END