Removal And Installation VDC/TCS/ABS

ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)


Removal and Installation


REMOVAL
1. Disconnect the battery cable from negative terminal.
2. Remove cowl top cover. Exploded View.
3. Drain brake fluid. Draining.
4. Disconnect ABS actuator and electric unit (control unit) harness connector.
5. Remove brake booster pressure sensor mounting bracket. Hang brake booster pressure sensor mounting bracket not to interfere with work.
6. Loosen brake tube flare nuts, then remove brake tubes from ABS actuator and electric unit (control unit). Exploded View.
7. Remove brake tube form between ABS actuator and electric unit (control unit) and master cylinder assembly. Exploded View.
8. Remove tire (front LH side).
9. Remove fender protector (rear): (front LH side). Exploded View.
10. Remove ABS actuator and electric unit (control unit) bracket mounting nut.
11. Remove ABS actuator and electric unit (control unit) from vehicle.

CAUTION:
- Never apply excessive impact to ABS actuator and electric unit (control unit), such as dropping it.
- Never remove actuator by holding harness.

INSTALLATION
Note the following, and install in the reverse order of removal.
- Install, use flare nut crowfoot and torque wrench. Exploded View.
- Never apply excessive impact to ABS actuator and electric unit (control unit), such as dropping it.
- Never install actuator by holding harness.
- After work is completed, bleed air from brake tube. Service and Repair.
- After installing harness connector in the ABS actuator and electric unit (control unit), make sure harness connector is securely locked.
- When replacing ABS actuator and electric unit (control unit), make sure to adjust neutral position of steering angle sensor. Description.