Removal And Installation VDC/TCS/ABS

WHEEL SENSOR


REAR WHEEL SENSOR : Removal and Installation


REMOVAL
Note the following, when removing sensor harness.
- Never twist sensor harness as much as possible, when removing it. Pull wheel sensors out without pulling sensor harness.
- Be careful to avoid damaging sensor edges or rotor teeth. Remove wheel sensor first before removing side flange. This is to avoid damage to sensor wiring and loss of sensor function.

INSTALLATION
Note the following, when installing wheel sensor. Tighten installation bolts to the specified torques.
- When installing, make sure there is no foreign material such as iron chips on and in the mounting hole of the wheel sensor. Make sure no foreign material has been caught in the sensor rotor. Remove any foreign material and clean the mount.
- When installing wheel sensor, be sure to press rubber grommets in until they lock at locations shown above in the figure. When installed, harness must not be twisted.