Automatic Drive Positioner Control Unit

POWER SUPPLY AND GROUND CIRCUIT - AUTOMATIC DRIVE POSITIONER CONTROL UNIT





Diagnosis Procedure

NOTE:
Do not disconnect the battery negative terminal and the driver seat control unit connector until DTC is confirmed using CONSULT-III.
1.CHECK POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Check voltage between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES - GO TO 2.
NO - 1 - Repair or replace harness between automatic drive positioner control unit and fuse block (J/B).
NO - 2 - Check circuit breaker.
2.CHECK GROUND CIRCUIT
Check continuity between the automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES - INSPECTION END
NO - Repair or replace harness.




Special Repair Requirement
1.PERFORM ADDITIONAL SERVICE
Perform additional service when removing battery negative terminal.
- Description.