Mirror Switch

DOOR MIRROR REMOTE CONTROL SWITCH - MIRROR SWITCH





Description
It operates angle of the door mirror face.
It transmits mirror face adjust operation to AUTOMATIC DRIVE POSITIONER CONTROL UNIT.




Component Function Check
1.CHECK MIRROR SWITCH FUNCTION
1. Turn ignition switch ON.
2. Select "MIR CON SW�UP/DN","MIR CON SW�RH/LH" in the "DATA MONITOR" mode using CONSULT-III.
3. Check mirror switch signal under the following conditions.





Is the inspection result normal?
YES - Mirror switch function is OK.
NO - Perform diagnosis procedure. SEE Diagnosis Procedure.




Diagnosis Procedure
1.CHECK MIRROR SWITCH INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect door mirror remote control switch connector.
3. Turn ignition switch ON.
4. Check voltage between door mirror remote control switch harness connector and ground.





Is the inspection result normal?
YES - GO TO 3.
NO - GO TO 2.
2.CHECK MIRROR SWITCH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit connector.
3. Check continuity between automatic drive positioner control unit harness connector and door mirror remote control switch harness connector.





4. Check continuity between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES - Replace automatic drive positioner control unit. Removal And Installation.
NO - Repair or replace harness.
3.CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Check continuity between door mirror remote control switch harness connector and ground.





Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace harness.
4.CHECK MIRROR SWITCH
Check door mirror remote control switch (mirror switch). SEE Component Inspection.
Is the inspection result normal?
YES - GO TO 5.
NO - Replace door mirror remote control switch (mirror switch). Removal And Installation.
5.CHECK INTERMITTENT INCIDENT
Check intermittent incident. Intermittent Incident.
- INSPECTION END




Component Inspection
1.CHECK MIRROR SWITCH
1. Turn ignition switch OFF.
2. Disconnect door mirror remote control switch connector.
3. Check continuity between door mirror remote control switch terminals.





Is the inspection result normal?
YES - INSPECTION END
NO - Replace door mirror remote control switch. Removal And Installation.