Removal and Installation

TRUNK LID


TRUNK LID STRIKER : Removal and Installation


TRUNK LID STRIKER

REMOVAL
1. Fully open trunk lid.
2. Remove trunk rear plate. Removal And Installation.
3. Remove BOSE amp (BOSE audio with navigation). Removal And Installation Bose Audio With Navigation.
4. Remove mounting bolts of trunk closure bracket.
5. Remove emergency cable from trunk closure assembly.
6. Disconnect harness connector from trunk closure assembly.
7. Disconnect harness connector from trunk closure control unit.
8. Remove mounting bolts. Remove trunk closure assembly.
9. Remove mounting screws. Remove trunk closure control unit.

CAUTION:
- Be careful that harness is not pinched when installing.
- Check the trunk lid open/close operation after installation.
- After installing, perform fitting adjustment. Trunk Lid Assembly.

EMERGENCY CABLE

REMOVAL
1. Remove pop-up roll bar. Removal And Installation.
2. Remove mounting bolts of emergency key cylinder bracket.
3. Remove emergency key cylinder bracket.
4. Remove mounting nuts. Remove emergency key cylinder.
5. Remove emergency cable from emergency key cylinder.
6. Remove trunk closure assembly.
7. Remove trunk floor trim (LH). Removal And Installation.
8. Disconnect each mounting clip of emergency cable.
9. Remove emergency cable.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Check the trunk lid open/close operation after installation.
- After installing, perform fitting adjustment. Trunk Lid Assembly.