Panic Alarm Function Does Not Operate

PANIC ALARM FUNCTION DOES NOT OPERATE





Description

NOTE:
- Before performing the diagnosis following procedure, check "Work Flow". Work Flow.
- Check that vehicle is under the condition shown in "Conditions of vehicle" before starting diagnosis, and check each symptom.

CONDITIONS OF VEHICLE (OPERATION CONDITIONS)
- Ignition switch is in OFF or LOCK position.
- Intelligent Key is removed from key slot.




Diagnosis Procedure
1.CHECK REMOTE KEYLESS ENTRY FUNCTION
Check remote keyless entry function.
Does door lock/unlock with Intelligent key button?
YES - GO TO 2.
NO - Go to System Description.
2.CHECK VEHICLE SECURITY ALARM OPERATION
Check vehicle security alarm operation.
Does alarm (headlamp and horn) active?
YES - GO TO 3.
NO - Go to System Description.
3.CHECK "PANIC ALARM SET" SETTING IN "WORK SUPPORT"
Check "PANIC ALARM SET" setting in "WORK SUPPORT". Consult-III Function (BCM - Intelligent Key).
Is the inspection result normal?
YES - GO TO 4.
NO - Set "PANIC ALARM SET" setting in "WORK SUPPORT".
4.CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES - Check intermittent incident. Intermittent Incident.
NO - GO TO 1.