C1719

C1716, C1717, C1718, C1719 TIRE PRESSURE SENSOR





DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.DTC REPRODUCTION PROCEDURE
With CONSULT-III
1. Turn the ignition switch ON.

CAUTION:
Never start the engine.
2. Check the tire pressure for all wheels and adjust to the specified value. [1][2]Specifications.
3. Perform "SELF-DIAG RESULTS" in "AIR PRESSURE MONITOR" of "BCM".
Is DTC "C1716", "C1717", "C1718", "C1719" detected?
YES - Perform trouble diagnosis. SEE Diagnosis Procedure.
NO - INSPECTION END




Diagnosis Procedure
1.CHECK TIRE PRESSURE
Check the internal pressure of all wheels. [1][2]Specifications.
Is the inspection result normal?
YES - Replace the DTC-detected malfunctioning tire pressure sensor. Exploded View.
NO - After adjusting the tire pressure, GO TO 2.
2.CHECK TIRE PRESSURE SIGNAL
With CONSULT-III
1. Check and adjust the tire pressure for all wheels. [1][2]Specifications.
2. Perform tire pressure sensor ID registration for all wheels. Service and Repair.
3. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.
4. Perform "DATA MONITOR" in "AIR PRESSURE MONITOR" of "BCM".
5. Select "BCM" in "DATA MONITOR", and check that the tire pressures match the standard value.

CAUTION:
Stop the vehicle and within 15 minutes, use CONSULT-III "DATA MONITOR" to display the tire pressure for all wheels.
6. Check that "DATA MONITOR" displays tire pressure of 438.60 kPa (4.47 kg/cm2, 63.60 Psi).
Is the inspection 438.60 kPa (4.47 kg/cm2, 63.60 Psi)?
YES - Replace tire pressure sensor the tire pressure 438.60 kPa (4.47 kg/cm2, 63.60 Psi) displayed. Exploded View.
NO - GO TO 1.