Diagnosis Procedure

SELECTOR LEVER POSITION INDICATOR


Description

Indicates selector lever position.




SELECTOR LEVER POSITION INDICATOR


Diagnosis Procedure

1.CHECK MALFUNCTIONING ITEM
Which item is abnormal?
Position indicator lamp- GO TO 2.
Illumination lamp- GO TO 10.
2.CHECK POWER SOURCE
1. Turn ignition switch OFF.
2. Disconnect A/T shift selector connector.
3. Turn ignition switch ON.
4. Check voltage between A/T shift selector vehicle side harness connector terminals.





Is the inspection result normal?
YES - GO TO 7.
NO - GO TO 3.
3.CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Check continuity between A/T shift selector vehicle side harness connector terminal and ground.





Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace damaged parts.
4.CHECK HARNESS BETWEEN A/T SHIFT SELECTOR AND BCM (PART 1)
1. Disconnect BCM connector.
2. Check continuity between A/T shift selector vehicle side harness connector terminal and BCM vehicle side harness connector terminal.





Is the inspection result normal?
YES - GO TO 5.
NO - Repair or replace damaged parts.
5.CHECK HARNESS BETWEEN A/T SHIFT SELECTOR AND BCM (PART 2)
Check continuity between A/T shift selector vehicle side harness connector terminal and ground.





Is the inspection result normal?
YES - GO TO 6.
NO - Repair or replace damaged parts.
6.CHECK MALFUNCTIONING ITEM
Check the following.
- Check terminals of BCM connector and A/T shift selector connector for damage.
- Check connector for loose connection.
Is the inspection result normal?
YES - Check BCM input/output signal. Pinout Values and Diagnostic Parameters.
NO - Repair or replace damaged parts.
7.CHECK SHIFT POSITION SWITCH
1. Disconnect selector lever position indicator connector.
2. Check continuity between A/T shift selector harness connector terminals and selector lever position indicator connector terminals.





Is the inspection result normal?
YES - GO TO 8.
NO - Repair or replace damaged parts. (2WD) or Exploded View (AWD).
8.CHECK SELECTOR LEVER POSITION INDICATOR
Check selector lever position indicator. Component Inspection.
Is the inspection result normal?
YES - GO TO 9.
NO - Replace damaged parts.
9.CHECK MALFUNCTIONING ITEM
Check the following.
- Check terminals of A/T shift selector connector, shift position switch connector and selector lever position indicator connector for damage.
- Check connector for loose connection.
Is the inspection result normal?
YES - Check intermittent incident. Intermittent Incident.
NO - Repair or replace damaged parts.
10. CHECK POWER SOURCE
1. Turn ignition switch OFF.
2. Disconnect A/T shift selector connector.
3. Turn ignition switch ON.
4. Check voltage between A/T shift selector vehicle side harness connector terminals.





Is the inspection result normal?
YES - GO TO 11.
NO - Check illumination circuit. Illumination.
11.CHECK SHIFT POSITION SWITCH
1. Disconnect selector lever position indicator connector.
2. Check continuity between A/T shift selector harness connector terminals and selector lever position indicator connector terminals.





Is the inspection result normal?
YES - GO TO 8.
NO - Repair or replace damaged parts. (2WD) or Exploded View (AWD).