Removal and Installation

TRANSVERSE LINK


Removal and Installation


REMOVAL
1. Remove tires with power tool.
2. Remove under cover with power tool.
3. Remove shock absorber. Exploded View.
4. Remove front crossbar.
5. Remove steering outer socket from steering knuckle. Exploded View.
6. Remove transverse link from steering knuckle.
7. Set suitable jack under transverse link.
8. Remove mounting bolts and nuts, and then remove transverse link.

INSTALLATION
Note the following, and install in the reverse order of removal.
- Never tap on the ball joint cap of the stabilizer connecting rod with a hammer or a similar item when inserting the stabilizer connecting rod into the transverse link.
- Perform final tightening of bolts and nuts at the front suspension member installation and shock absorber lower side (rubber bushing), under unladen conditions with tires on level ground.