Inspection

FRONT WHEEL HUB AND KNUCKLE


Inspection


MOUNTING INSPECTION
Check that the mounting conditions (looseness, backlash) of each component and component conditions
(wear, damage) are normal.

WHEEL BEARING INSPECTION
- Move wheel hub and bearing assembly in the axial direction by hand. Check there is no looseness of wheel bearing.

Axial end play : Refer to FAX-9, "Wheel Bearing". Front Axle

- Rotate wheel hub and bearing assembly and check that is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub and bearing assembly.





FRONT WHEEL HUB AND KNUCKLE


Inspection


INSPECTION AFTER REMOVAL
Check components for deformation, cracks, and other damage. Replace it if necessary.

Ball Joint Inspection
Check boots of transverse link and steering outer socket ball joint for breakage, axial play, and torque. Transverse Link and Inspection.

INSPECTION AFTER INSTALLATION
1. Check wheel sensor harness for proper connection. Exploded View.
2. Check the wheel alignment. Front Suspension.
3. Adjust neutral position of steering angle sensor. Description Special Repair Requirement Description Special Repair Requirement, "ADJUSTMENT OF STEERING ANGLE
SENSOR NEUTRAL POSITION : Special Repair Requirement".