Diagnosis Procedure

TILT MOTOR


Description

- The tilt motor is installed to the steering column assembly.
- The tilt motor is activated with the automatic drive positioner control unit.
- The steering column is tilted upward/downward by changing the rotation direction of tilt motor.




TILT MOTOR


Diagnosis Procedure

1.CHECK TILT MOTOR POWER SUPPLY
1. Turn ignition switch OFF.
2. Disconnect tilt & telescopic motor connector.
3. Turn ignition switch ON.
4. Perform "Active test" ("TILT MOTOR") using CONSULT-III.
5. Check voltage between tilt & telescopic motor harness connector and ground.





Is the inspection result normal?
YES - Replace tilt motor. (Built in steering column assembly.) Exploded View Removal and Installation, "WITH ELECTRIC
MOTOR : Exploded View".
NO - GO TO 2.
2.CHECK TILT MOTOR CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit connector.
3. Check continuity between automatic drive positioner control unit harness connector and tilt & telescopic motor harness connector.





4. Check continuity between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES - Replace automatic drive positioner control unit. Automatic Drive Positioner Control Unit.
NO - Repair or replace harness.