B. Loading the Program
B: Loading the ProgramNOTE:
This procedure will take about 30 minutes with the ignition ON. Before starting make sure to attach a battery charger to the vehicle battery set to a low charge rate (trickle charge).
1. Turn the ignition ON - keep the transmission in Park or Neutral. The navigation start-up screen should display.
NOTE:
If the navigation start-up screen is not displayed; turn the ignition OFF wait 10 seconds and then turn the ignition ON again.
2. Wait for more than 1 minute.
3. Press the INFO button on the switch panel.
4. Select Navigation Version on the display screen.
NOTE:
On some vehicles you will need to select "Others" to find "Navigation Version".
5. Check "Map Version".
^ If map version is 09-10 MAP No.1b:
a. Insert Disc 3/3 in the in-dash CD / DVD player.
Disc 1/3 and 2/3 will not be needed.
b. Skip to Step 18.
^ If the Map Version is any other then above continue with Step 6.
6. Make sure there is no disc in the CD/DVD slot (eject any disc that may be in the CD/DVD player).
7. Insert disc 1/3 into the in-dash CD/DVD player.
IMPORTANT: Once reprogramming has started:
^ Do not eject a disc while it is loading.
^ Do not change the ignition position until all discs have been loaded.
^ Make sure all 3 discs have been loaded into the CD/DVD player before stopping the procedure.
8. Wait for the program to load (progress bar will display).
9. When the program has finished loading:
^ Disc 1 will automatically eject and
^ "Program loading is completed" will display.
10. Carefully remove disc 1/3.
11. The navigation system will automatically restart.
12. When the message "Please insert Disc 2/3" displays insert, Disc 2/3.
13. Touch "DVD update".
14. Touch "Yes" to begin the map update process
^ Map update will take about 15 minutes.
15. When "Eject the DVD to let the system reboot" is displayed eject Disc 2/3.
16. The navigation system will automatically restart.
17. When the message "Please insert Disc 3/3" displays insert Disc 3/3.
18. Program loading will start automatically.
^ Program loading will take about 10 minutes.
19. When the program has finished loading:
^ Disc 3/3 will automatically eject, and
^ "Program loading is completed" will display.
20. Carefully remove disc 3/3
21. The navigation system will automatically restart.
22. Make sure the new program has loaded:
a Press the INFO button.
b. Select Navigation Version on the display screen.
NOTE:
On some vehicle you will need to select "Others" to find "Navigation Version".
d. Map Version should be 09-10 MAP No.1b
e. Program Version should be:
X1U52008 or X2U12052
NOTE:
If the Map Version or the Program version is not as above go back to Step 5 under "B Loading the Program".
23. Go to C: Check Bluetooth(R) Setting.