C1711

C1708, C1709, C1710, C1711 TRANSMITTER





DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.DTC REPRODUCTION PROCEDURE
With CONSULT-III
1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.
2. Perform "SELF-DIAG RESULTS" in "AIR PRESSURE MONITOR" of "BCM".
Is DTC "C1708", "C1709", "C1710", "C1711" detected?
YES - Perform trouble diagnosis. C1708.
NO - INSPECTION END




Diagnosis Procedure
1.CHECK TIRE PRESSURE SIGNAL
With CONSULT-III
1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.
2. Perform "DATA MONITOR" in "AIR PRESSURE MONITOR" of "BCM".
3. Select "BCM" in "DATA MONITOR", and check that the tire pressures match the standard value.





Is a tire pressure of 0 kPa (0 Psi) displayed for all wheels?
YES - GO TO 2.
NO - GO TO 5.
2.CHECK HARNESS BETWEEN BCM AND TIRE PRESSURE RECEIVER
1. Turn the ignition switch OFF.
2. Disconnect BCM harness connector and tire pressure receiver harness connector.
3. Check the continuity between BCM harness connector and tire pressure receiver harness connector.





4. Check the continuity between BCM harness connector and ground.





Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace damaged parts.
3.CHECK TIRE PRESSURE RECEIVER POWER SUPPLY CIRCUIT
1. Connect the BCM harness connector.
2. Turn the ignition switch ON.

CAUTION:
Never start the engine.
3. Check the voltage between the BCM harness connector and ground.





Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace damaged parts.
4.CHECK TIRE PRESSURE RECEIVER
Check tire pressure receiver. Testing and Inspection.
Is the inspection result normal?
YES - GO TO 5.
NO - Replace tire pressure receiver. Exploded View.
5.CHECK ID REGISTRATION
Perform ID registration of all transmitters. Special Repair Requirement.
Can ID registration of all transmitters be completed?
YES - GO TO 6.
NO - Replace transmitter. Exploded View.
6.CHECK TIRE PRESSURE MONITORING SYSTEM
With CONSULT-III
1. Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
2. Perform "DATA MONITOR" in "AIR PRESSURE MONITOR" of "BCM".
3. Select "BCM" in "DATA MONITOR", and check that the tire pressures match the standard value.





Is the inspection result normal?
YES - Replace the DTC-detected malfunctioning transmitter. Exploded View.
NO - Replace BCM. Exploded View.




Special Repair Requirement
1.CHECK TIRE AIR PRESSURE
Check all tire air pressures. Specifications.
Does all tire pressure data meet the specification?
YES - GO TO 2.
NO - Inspect or repair the tires or wheels and adjust the tire pressure to the specification.
2.PERFORM ID REGISTRATION
Perform ID registration. Special Repair Requirement.
- END