Removal and Installation

CONTROL DEVICE


Removal and Installation


REMOVAL

CAUTION:
Make sure that parking brake is applied before removal/installation.
1. Move selector lever to "N" position.





2. Remove knob cover (1) below selector lever downward.
3. Pull lock pin (3) out of selector lever knob (2).
4. Remove selector lever knob.
5. Remove cup holder, switch finisher, cluster lid C and A/T console finisher. Refer to Cluster Lid C
6. Remove center console. Refer to Locations.
7. Disconnect A/T shift selector harness connector.
8. Remove A/T shift selector assembly.

INSTALLATION
Note the following, and install in the reverse order of removal.
- When installing control rod to A/T shift selector assembly, refer to "ADJUSTMENT". Refer to 7AT RE7R01A.