Removal And Installation

OIL PAN


Removal and Installation


REMOVAL
1. Drain ATF through drain plug.
2. Remove exhaust mounting bracket with a power tool. Refer to Component.





3. Disconnect heated oxygen sensor 2 connectors (A).
4. Remove heated oxygen sensor 2 harness (B) from clips (1).
5. Remove bracket (2) from A/T assembly. Refer to Exploded View.





6. Remove clips (1).
7. Remove oil pan (2) and oil pan gasket.
8. Remove magnets from oil pan.

INSTALLATION
Note the following, and install in the reverse order of removal.

CAUTION:
- Never reuse drain plug and drain plug gasket.
- Clean foreign materials (gear wear particles) that adhere on the inside of the oil pan and on the magnet, and then assembly.





- Refer to the followings when installing oil pan (2) (with oil pan gasket) and clips (1) to transmission case.

CAUTION:
- Never reuse oil pan gasket and oil pan mounting bolts.
- Completely remove all moisture, oil and old gasket, etc. from oil pan gasket mounting surface of transmission case and oil pan.
- Install oil pan gasket in the direction to align hole position.





- Tighten oil pan mounting bolts to the specified torque in numerical order shown in the figure after temporarily tightening them.