Antitheft - Windows Move When Closing Glove Box
Classification: EL09-003Reference: ITB09-025
Date: May 12, 2009
2008 - 2009 G37 COUPE; WINDOWS MOVE DOWN / UP WHEN GLOVE BOX IS CLOSED
APPLIED VEHICLE:
2008 - 2009 G37 Coupe (CV36) with Vehicle Security System (VSS) accessory impact sensor installed.
IF YOU CONFIRM
When the glove box is pushed from open to close the side windows move down about an inch and then back up.
ACTION:
1. Disconnect the impact sensor brown wire.
2. Reconnect the impact sensor brown wire in the new (correct) location (see Service Procedure).
CLAIMS INFORMATION
IMPORTANT:
The purpose of "ACTIONS" (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire Service Procedure as it contains information that is essential to successfully completing this repair.
SERVICE PROCEDURE
1. Write down the radio station presets.
2. Write down / record the following customer settings for the ATC (Automatic Temperature Control) system. (Refer to the Service Manual as needed):
^ Temperature Setting Trimmer
^ Foot Position Setting Trimmer
^ Inlet Port Memory Function
3. Turn the ignition OFF.
4. Disconnect the negative battery cable.
5. Remove / disconnect the impact sensor Brown wire from the Light Green wire in BCM connector 123, cavity 124 (see Figure 1).
^ To access the BCM, refer to the Service Manual.
^ Do not damage the Posi-Tap(R) - it will be reused to reattach the brown wire.
^ If needed, refer to Posi-Tap(R).
6. Tap / connect the impact sensor Brown wire to the Red wire in BCM connector 121, cavity 50 (see Figure 2).
^ Reuse the Posi-Tap�(R) for wire connection.
^ If needed, refer to Posi-Tap(R).
7. Apply electrical tape to the Posi-Tap(R) and Brown wire as shown in Figure 3.
a). Secure the brown wire to the side of the Posi-Tap� with electrical tape ( 2 revolutions).
b). Secure the Red wire with electrical tape as shown ( 2 revolutions).
8. Connect the negative battery cable.
9. Reset the clock and the radio station presets.
10. Refer to the Service Manual for the following "reset / relearn" procedures:
^ Power Window Initialization
^ ATC Temperature Setting Trimmer (A/C system)
^ ATC Foot Position Setting Trimmer (A/C system)
^ ATC Inlet Port Memory Function (A/C system)
^ Rear View Monitor Possible Route Line Center Position Adjustment (if equipped)
11. Inform the customer they will need to "reset" their Automatic Drive Positioner.
Posi-Tap(R) Use
1. Tap vehicle wire.
a). Remove cap (slot side) from tap body.
b). Slide cap around vehicle wire.
c). Tighten the tap TIGHT with finger pressure.
2. Inspect the tap to ensure correct installation.
3. Tap the wire from the Impact Sensor.
a). Remove tap from non-pierce side.
b). Remove protective stub from wire (new wire only).
c). Insert the wire through the non-pierce side opening.
d). Spread the individual strands into a fan Shape.
e). Insert wire into the tap body and ensure that it is all the way in.
f). Tighten the tap TIGHT with finger pressure.
4. Inspect the tap to ensure correct installation.