P1705

P1705 THROTTLE POSITION SENSOR





Description
Electric throttle control actuator consists of throttle control motor, accelerator pedal position sensor, throttle position sensor, etc. The actuator transmits a signal to the ECM, and ECM transmits signals to TCM via CAN communication.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
- GO TO 2.
2.CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "SLCT LVR POSI" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for 5 seconds or more.

SLCT LVR POSI : D
VHCL/S SE-A/T : 5 km/h (3 MPH) or more

4. Perform "Self Diagnostic Results" in "TRANSMISSION".
Is "P1705" detected?
YES - Go to P1705.
NO - INSPECTION END




Diagnosis Procedure
1.CHECK DTC OF ECM
With CONSULT-III
1. Turn ignition switch ON.
2. Perform "Self Diagnostic Results" in "ENGINE".
Is any DTC detected?
YES - Check DTC detected item. Refer to Testing and Inspection.
NO - GO TO 2.
2.CHECK DTC OF TCM
With CONSULT-III
Perform "Self Diagnostic Results" in "TRANSMISSION".
Is any DTC detected?
YES - Check DTC detected item. Refer to Testing and Inspection.
NO - GO TO 3.
3.CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
Is the inspection result normal?
YES - Replace A/T assembly. Refer to Exploded View (2WD), Exploded View (AWD).
NO - Repair or replace damaged parts.