Diagnosis Procedure

RAIN SENSOR


Diagnosis Procedure

1.CHECK RAIN SENSOR FUSE
1. Turn the ignition switch OFF.
2. Check that the rain sensor 10A fuse (#6) is not fusing.
Is the fuse fusing?
YES - Replace the fuse after repairing the applicable circuit.
NO - GO TO 2.
2.CHECK RAIN SENSOR POWER SUPPLY
1. Turn ignition switch OFF.
2. Disconnect rain sensor connector.
3. Turn ignition switch ON.
4. Check voltage between rain sensor harness connector and ground.





Is the measurement value normal?
YES - GO TO 3.
NO - Repair or replace harness.
3.CHECK RAIN SENSOR GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Check continuity between rain sensor harness connector and ground.





Does continuity exist?
YES - GO TO 4.
NO - Repair or replace harness.
4.CHECK RAIN SENSOR SIGNAL
1. Connect rain sensor connector.
2. Turn ignition switch ON.
3. Check signal between BCM harness connector and ground with oscilloscope.





Is the measurement value normal?
YES - Replace rain sensor. Refer to Exploded View.
NO - GO TO 5.
5.CHECK RAIN SENSOR SIGNAL CIRCUIT FOR OPEN
1. Disconnect BCM connector.
2. Check continuity between BCM harness connector and rain sensor harness connector.





Does continuity exist?
YES - GO TO 6.
NO - Repair or replace harness.
6.CHECK RAIN SENSOR SIGNAL CIRCUIT FOR SHORT
Check continuity between BCM harness connector and ground.





Does continuity exist?
YES - Repair or replace harness.
NO - Replace BCM. Refer to Exploded View.