Diagnosis Procedure

SLIDING MOTOR


Description

- The seat sliding motor is installed to the seat cushion frame.
- The seat sliding motor is activated with the driver seat control unit.
- The seat is slid frontward/rearward by changing the rotation direction of sliding motor.




SLIDING MOTOR


Diagnosis Procedure

1.CHECK SLIDING MOTOR POWER SUPPLY
1. Turn ignition switch OFF.
2. Disconnect sliding motor connector.
3. Turn the ignition switch ON.
4. Perform "Active test" ("SEAT SLIDE") using CONSULT-III
5. Check voltage between sliding motor harness connector and ground.





Is the inspection result normal?
YES - Replace sliding motor. (Built in seat slide cushion frame.) Refer to Exploded View.
NO - GO TO 2.
2.CHECK SLIDING MOTOR CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect driver seat control unit connector.
3. Check continuity between driver seat control unit harness connector and sliding motor harness connector.





4. Check continuity between driver seat control unit harness connector and ground.





Is the inspection result normal?
YES - Replace driver seat control unit. Refer to Driver Seat Control Unit.
NO - Repair or replace harness.