Special Repair Requirement

INSPECTION AND ADJUSTMENT


INITIALIZATION WITH CONSULT-III : Special Repair Requirement

1. STEP 1
1. Start engine.
2. Fully close retractable hard top.
- GO TO 2.
2. STEP 2
Check the operation.
What was the operation performed?
Replace or remove and install roof components.-GO TO 3.
Replace retractable hard top control unit.-GO TO 4.
3. STEP 3
Perform "ROOF STATE RESET" on "Work Support" using CONSULT-III and erase the current memorized position. Refer to Scan Tool Testing and Procedures.
- GO TO 4.
4. STEP 4
Perform "ROOF STATE LEARNING" on "Work Support" using CONSULT-III and memorize the new roof position. Refer to Scan Tool Testing and Procedures.
Fully close the roof and repeat this operation (STEP 4) , if roof warning buzzer sounds twice or does not sound during the initialization.

NOTE:
Retractable hard top operation during this procedure is as per the following items.
1. Roof warning buzzer sounds once at the same time retractable hard top open operation is performed by roof open/close switch (OPEN) operation, after touching "Start" on CONSULT-III screen.
2. Roof warning buzzer sounds once when the roof is fully open.
3. Roof warning buzzer sounds once at the same time retractable hard top close operation is performed by roof open/close switch (CLOSE) operation.
4. Roof warning buzzer sounds once when the roof is fully closed.
- GO TO 5.
5. STEP 5
Check that retractable hard top operates normally by operating from fully closed to fully open positions and from fully open to fully closed positions.
- WORK END